L2 vfi manual

1.!Configure a VFI on PE routers: Here is an example of VFI configuration for R1 config t l2 vfi VPLS-CUST1-ETHERNET manual Enable the Layer 2 VFI manual configuration mode. The name of the VFI is VPLS-CUST1-ETHERNET. Neighbors will be set up manually. The virtual forwarding interface (VFI) specifies the VPN ID of a VPLS domain, the addresses of. Router(config)#l2 vfi vfi-name manual. Enables the L2 VFI manual configuration mode. Router(config-vfi)#vpn id oui:vpn-index. Configures a VPN ID for a VPLS domain. The emulated VCs bound to this L2 VRF use this VPN ID for signaling. Router(config-vfi)#neighbor remote-router-id encapsulation mpls. l2 vfi VPLS manual vpn id neighbor encapsulation mpls! interface Vlan3xconnect vfi VPLS! Note: Obviously the physical interface connected to the clients, needs to be in VLAN , and don’t forget (at both ends), to make sure that vlan is up (no shut).

l2 vfi name manual. Router(config)# l2 vfi vfi17 manual Enables the Layer 2 VFI manual configuration mode. Step 2. vpn id vpn-id. Router(config-vfi)# vpn id Configures a VPN ID for a VPLS domain. The emulated VCs bound to this Layer 2 VRF use this VPN ID for signaling. Step 3. neighbor remote router id {encapsulation mpls} [no-split-horizon]. With the use of “no-split-horizon” command during the VC configuration, we can disble the default L2 split-horizon rule and configure multiple VCs per spoke into the same VFI. As an example: Router1(config-vfi)# neighbor encapsulation mpls split-horizon Let’s see the VPLS (Virtual Private LAN Service) Configuration on each device. In this video, we'll take a look at the older L2VPN configuration options.

27 de mar. de router (config)# l2 vfi manual router(config-vfi)# vpn id To verify that the VFI is in a UP or DOWN state run the command below. L2 Vfi Manual Through Loopback PA MC 8TE1 + Port Adapter Cisco Systems MP3 Player User F8e23f62 1edb d Be55 baec User Manual: Cisco Systems. xconnect vfi VLAN ASR l2 vfi VLAN manual vpn id bridge-domain neighbor pw-class PWE3_Force_Tu